Polishing your chamber with some steel wool wrapped around a cleaning brush chucked up in a cordless drill will clean it right up. Then when the shell is fired this steel head will expand into these minuet imperfections, this extra friction can cause the issues you describe. If the heads are steel instead of brass and your chamber is or has been rough, pitted, rusted, ect. Next, lets talk ammo! What are you using? I will check my notes when I get home to let you know the exact diameter of the holes, but two open holes should allow it enough gas to function all day long. I think a 1/16" (.0625) drill bit will also pass thru and clean out any crude buildup in each hole. 060 mig welding wire thru both, keep in mind that the holes angle backwards, but you need to visibly see the wire protrude into the barrel. Make certain the both gas ports are open by pushing a piece of. Normally it is staked in (this is the dents you see)Īs stated you will have to tap it back in flush, brownells sells a staking tool that will allow you to restake it, but I have had excellent results using super glue. The feed latch needs to be held in place for you gun to function properly.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |